TM 9-4120-371-14
S e c t i o n II MAINTENANCE PROCEDURES
5-2. AIR CONDITIONER (FABRIC) COVER
a. Repair. Minor rips, cuts, tears, or punctures may be repaired by applying a patch to the inside surface.
b. Replace. For damage of greater extent, or missing eyelets or snap fasteners, replace the entire cover.
5-3. OUTSIDE COVERS, PANELS, GRILLES, SCREENS, INFORMATION PLATES
a. For removal, inspection, cleaning, and installation, see the following paragraphs:
CBR (Chemical, Biological, Radiological) duct cover (See para 4-20.)
Side access plate (See para 4-22.) (Effective for Keco Model F18T-2S Serial No's. 82760 and
higher, Keco Model F18T2SA, and A.R.E. Model CVP-20-5/6-08.)
Conditioned air discharge (outlet) grille assembly (See para 4-24.)
Conditioned air intake grille assembly (See para 425.)
Filter (radio frequency) mounting plate (See para 4-32.)
b. Repair. Repairs are limited to straightening of minor dents, rewelding of broken welds, installation of
loose or missing rivets, replacement of loose or missing gaskets and insulation, paint touch up, and
replacement of damaged or missing name plates.
(1) Repair minor dents using standard sheet metal repair practices.
(2) Repair broken welds using standard weld repair practices.
(3) To replace loose or missing rivets:
Drill old rivet out using a drill bit slightly smaller than the diameter of old rivet body.
Install replacement rivet.