ARMY TM 9-4120-380-14
NAVY EE-000-BA-MMA-010/7053-AC
AIR FORCE TO 35E9-136-21
6.6
CONDENSER DUCT. - Continued
REMOVAL
a.
Remove six rivets (3) securing duct (4) to back of frame (see fig 6-1).
b.
Lilt duct over thermostatic expansion valve and remove duct (4).
INSPECTION
a.
Check duct (4) for damage.
b.
Check for proper operation of damper (10) and pivot shaft (11)
c.
Check that gasket (5) Is not damaged or missing rivets (7).
REPAIR/REPLACE
NOTE
Repair consists of replacing gasket, damper and/or pivot shaft,
a.
Gasket.
(1) Remove 9 or 10 rivets (7) from bracket (6).
(2) Remove damaged gasket (5).
(3) Cut gasket (5) to fit.
(4) Install gasket (5) and bracket (6) with 9 or 10 rivets (7).
b.
Damper and Pivot Shaft.
(1) Remove two screws (1), four flat washers (9) and (12), and two self-locking nuts (8) securing damper
(10) to pivot shaft (11).
(2) Remove pivot shaft (11).
(3) Remove damper (10).
(4) Position damper (10) in condenser duct (4).
(5) Install pivot shift with two screws (1), four flat washers (9) and (12), and two locknuts (8).
6-4