TM 9-4120-388-14
4-6. AIR CONDlTlONER PREPARATION FOR INSTALLATION.
a. General. No preparation is necessary if the air conditioner is to be installed by the typical exterior wail opening meth-
od and operated as a self-contained unit. For alternate installation methods, some preparation is necessary.
b. The unit is designed to provide for several basic types of installation. Seethe following paragraphs for instruc-
tions only if they are applicable to your requirements.
(1)
When power and/or control cable(s) are to be connected through the return air duct, see para 4-8.
Alternate input power cable connector locations. (See para 4-9.)
(2)
Installations that require removal of the fabric cover. (See para 4-10.)
(3)
(4)
Remove control panel mounting.
4-7. REMOTE MOUNTING OF
CONTROL PANEL. This paragraph is
applicable only when the control panel is to be
re-
mounted. If the control panel is to be removed from the unit and installed in a remote location, follow instructions of this paragraph
Be sure input power Is disconnected before doing any work inside the air condi-
tioner cabinet. Voltages used can be lethal.
Loosen two captive panel fasteners in lower front panel.
a.
b. Tip top of lower front panel away from unit and lift panel up to dear flange on bottom of panel.
Loosen six captive tumlock stud fasteners in intake grille assembly.
c.