TM 9-4120-388-14
5-24. EVAPORATOR COIL - Continued.
While handling coils, wear gloves to avoid cuts and reduce fin damage on the coil.
(7) Remove eight screws and packing with retainers while supporting the evaporator coil.
(8) Remove two screws that attach mist eliminator brackets to coil.
(9) Remove mist eliminator brackets.
(10) Remove three screws and flat washers from each of the evaporator coil brackets.
(11) Slip evaporator coil brackets up and out of unit.
(12) Remove screw, Iockwasher, flat washer, and clamp from distributor lines.
(13) Using gloves to protect your hands and coil fins, carefully lift the coil up and out of the unit.
b. Repair.
(1) Repairs are limited to replacement of rivets, plate nuts, and straightening of mashed fins.
(2) Plate nuts may be removed by drilling out old rivets using a drill bit slightly smaller than the diameter of the
rivet.
5-60