TM9-4120-400-14
4-16.
MIST ELIMINATOR. - continued
Figure 4-12. Mist Eliminator
REMOVAL
1. Remove eight screws (1) and top front panel (2).
2. Pull mist eliminator (3) up and out of mounting frame.
Dry cleaning solvent used to clean parts is potentially dangerous to personnel and
property. Do not use near open flame or excessive heat. Use in well ventilated area.
CLEANING
1.
Immerse in a detergent solution or dry cleaning solvent.
2.
Agitate until dirt is removed, using a soft brush if necessary to loosen caked-on dirt.
3.
Rinse in clean water.
4.
Drain, then hold horizontal and tap each edge on bench or floor to dislodge droplets.
INSPECTION
1. Check mist eliminator (3) for punctures, cuts, and damaged edges that would allow air to bypass.
2. Check mist eliminator (3) for packed or mashed areas that would block airflow.
3. Replace mist eliminator (3) if found bad.
4-48