TM9-4120-401-14
4-38. RECTIFIER (CR1) AND CAPACITORS
(C1 AND C2). - continued
(6) Discard old insulation sleeving (7) from capaoitors (2) and (3) leads.
(7) Cut four pieces of new insulation sleeving (7) to a length of 3/4 inch (1.8 cm).
(8) Slip insulation sleeving (7) over capacitors (2) and (3) leads and solder wire and capacitor leads in place
(9) Secure rectifier (1) in plaoe with screw (4), lock washer (5 ), and flat washer (6).
(10) Replace rectifier (1) and capacitors (2) and (3) if any one component is defective.
c. Replace.
(1) Using a tool with an insulated handle, ehort across capaoitor terminals to discharge them.
(2) Tag and unsolder wire leads from rectfiier (1) terminals. (See paragraph 4-24.)
(3) Remove screw (4), lock washer (5), flat washer (6), and rectifier (1).
(4) Cut four pieces of insulation sleeving (7) to a length of 3/4 Inch (1.8 cm).
(5) Slip insulation sleeving (7) over capacitors (1) and (2) leads and solder wire and capacitor leads in place
(6) Secure in place using screw (4), Iock washer (5), and flat washer (6).
NOTE
FOLLOW-ON MAINTENANCE:
Connect power at power source.
4-94