TM9-4120-401-14
PANELS - continued.
5-5.
(5) Starting with an end, carefully attach material to the metal. Press into firm contact all over.
(6) Minor dents and bent edges can be straightened using common sheet metal repair procedures.
(7) Should touch up or refinishing be necessary, see TM 43-0139.
b. Replace.
Replace panels that are badly dented, bent, or punctured.
NOTE
FOLLOW-ON MAINTENANCE:
Connect power at power source,
INFORMATION PLATES.
Replace
This task covers:
INITIAL SETUP
Equipment Conditions
TOOIS
Refrigeration Unit Service Tool Kit
Brush
Use disconnect switch (NOT
POWER CABLE) to disconnect
power to unit. Damage to cable
Gloves
connector pins will result if cable is
used.
Rivet Gun
Disconnect power at power source.
Materials/Parts
Adhesive Remover
Rivets
NOTE
See figure 2-6 for location and information contained on information plates.
Use only information plates identified in TM 9-4120-401-24P.
5-8