TM 9-4120-401-14
5 - 3 2 . LIQUID INDICATOR (SIGHT GLASS). - continued
Replace.
(3) Braze new liquid indicator (2) onto condenser coil tube. (See paragraph 5-14.)
NOTE
FOLLOW-ON MAINTENANCE:
This task covers:
a. Test
b. Repair
c. Replace
INITIAL SETUP
Equipment Condition
TooIs
Refrigeration Unit Service Tool Kit
Materials/Parts
Use disconnect switch (NOT POWER
CABLE) to disconnect power to unit.
Damage to cable connector pins will
result if cable is used.
Heater
Disconnect power from power source.
Connector J11
Lock Washers (4)
Personnel Required
Tiedown Strap
Two
Mounting Plate
(1) Disconnect wiring harness from connector J11.
(a) Check for continuity between pins G and F. If there is no continuity between these pins, heater is bad
and should be replaced.
5-76