TM 9-4120-401-14
This task covers:
a. Inspect
b. Replace
INITIAL SETUP
Tools
Equipment Condition
Refrigeration Unit Service Tool Kit
Materials/Parts
Use disconnect switch (NOT POWER
CABLE) to disconnect power to unit.
Receiver
Damage to cable connector pins will
result if cable is used.
Disconnect power from power source.
a. lnspect.
Check receiver (1) for dents or any other signs of damage. Replace if damaged.
b. Replacement.
(3) Remove four screws (2) and two retaining straps (3).
(5) Position new receiver (1) in place and braze two lines (4) to condenser coil (5). (See paragraph 5-14.)
(6) Secure receiver with two retaining straps (3) and four screws (2).
NOTE
FOLLOW-ON MAINTENANCE:
5-81