TM 9-4120-402-14
4-22. REAR PANEL.- continued
c.
Inspect.
(1) Check that panel (4) is not bent, cracked, or punctured. If damaged, notify supervisor.
(2) Check that gasket and insulation (17) are not tom, loose, or missing. If damaged, notify supervisor.
(3) Check that information plates (18)are readable and secure. If damaged, notify supervisor.
d. Install.
(1) Secure protective cover (13) to rear panel (4) and circuit breaker with six screws (12).
(2) Secure ground lug to rear panel (4) with two sets of nuts (14), flat washers (15), and lock washers (16).
(3) Reaching through top, position sight glass bracket (8) in place. Secure sight glass bracket to rear panel,
(4) with two sets of screws (9), lock washers (10) and packing with retainers (11).
(4) Secure pressure cut-out switch bracket to rear panel (4) with two sets of screws (5), lock washers (6), and flat
washers (7).
(5) Secure rear panel (4) to casing with twenty-one flat head screws (1) and twenty-four sets of pan head screws
(2) and flat washers (3).
NOTE
FOLLOW-ON MAINTENANCE:
Connect power at power source.
4-76