TM 9-4120-403-14
Removal
Remove sixteen screws, rain seal washers, and top panel.
Inspection
(1)
Check that panel is not bent, cracked, or punctured.
(2)
Check that gaskets and insulation are not torn, loose, or missing. Repair damaged gaskets and insulation.
Repair
(1)
Remove as much old gasket or insulation material as possible, by pulling or scraping away from the metal
surface.
(2)
Soften and remove old adhesive and gasket or insulation residue, using toluene and a stiff brush.
(3)
Cut replacement gasket or insulation to size per dimensions in Appendix F.
(4)
Be sure that the surface to which the gasket or insulation is to be applied is clean and free of old adhesive
material.
(5) Coat the mating surfaces of the metal and the gasket or insulation with adhesive. Let both surfaces air dry
until the adhesive is tacky, but will not stick to fingers.
(6)
Starting with an end, carefully attach the gasket or insulation to the metal. Press into firm contact all over.
Installation
Reinstall top panel, sixteen screws and rain seal washers.
Follow-on procedures:
1. Install fabric cover.
2. Connect power cord.
4-34