TM 9-4120-403-14
Replacement
(1) Tag and disconnect wires.
CAUTION
Take care that sensing bulb capillary line is not kinked and that bulb and capillary are not cut or damaged
during installation
(2) Remove four screws, locknuts and TEMPerature control thermostat.
(3) Secure TEMPerature control thermostat to rear panel with four screws and locknuts.
(4) Place capillary line through notch and split grommet in rear panel.
(5) Secure capillary tube and grommet in panel with adhesive.
(6) See tags and wiring diagram (fig. 4-43) and connect leads.
(7) Insert rear panel into box and aline holes.
CAUTION
Be sure no internal wiring interferes with shaft rotation
(8) Secure rear panel with four screws and locknuts.
(9) Place TEMPerature control thermostat knob on shaft and aline setscrews with flat on shaft.
(10) Tighten setscrews.
Follow-on procedure: Install control panel. (See para 4-26.)
4-63