TM 9-4120-403-14
(c) Wrap nearby areas except joint with wet rags to act as a heat sink.
NOTE
For ease of removal, break discharge line at tee above compressor. Remove compressor with stubby
process tube and short length of discharge line ("S" shaped) attached to compressor.
(d) While purging the system with nitrogen, debraze the tubing. (See paras 5-8 and 5-9.)
(e) Remove four locknuts and flat washers from top of mounting feet and four shoulder bolts, four oversize flat
washers, and four rubber washers from underside of unit.
Figure 5-24. Compressor (B1)
5-77