TM 9-4520-260-13
4-14.
RAIN SHIELD
This task covers:
a. Removal
b. Inspection
c.
Installation
INITIAL SETUP
General Safety Instructions
Tools
Tool Kit, Service Refrigeration Unit
Equipment Condition
The ignition system of this heater contains dangerous
Power disconnected and fuel supply turned off.
voltages which can cause severe electrical shock. Be
sure to disconnect power before any maintenance actions.
1.
Remove six screws (1) securing rain shield cover (2)
to rain shield (3). Remove cover.
2.
Remove four nuts (4) from studs securing rain shield
(3) to back heater case. Remove rain shield from
heater.
INSPECTION
Inspect rain shield and cover for damage, make sure rain
shield can be secured, and the cover can be installed
upside down.
INSTALLATION
1.
Install rain shield (3) to studs on heater case and
secure with four nuts (4).
2.
Install rain shield cover (2) and secure with six screws
(1).
Figure 4-8. Replacing Rain Shield.
4-20