TM 9-4520-260-13
5-8. HEATER CASE
This task covers:
a. Inspection
b. Repair
INITIAL SETUP
Tools
Material/Parts
Tool Kit, Service Refrigeration Unit
Gasket
Rivet
Shop Set, Automotive Vehicle
Riveter, Blind, Hand
Equipment Condition
Heater removed from its installation.
Cover panels removed as required for access
Inspect threaded mounts (2), camloc receptacles (4), and exhaust connector (6) for any damage. Replace any
defective parts.
REPAIR
1. Threaded Mounts.
a. Remove two screws (1) securing each of the four threaded mounts (2) to heater case (3).
b. Install four threaded mounts (2) and secure each with two screws (1).
2. Camloc Receptacle.
a. Using a .125-inch diameter drill bit, drill out two rivets (5) that secure each of the eight camloc receptacles (4) to
heater case (3).
b. Install camloc receptacles (4) and secure with rivets (5) using a rivet gun.
5-22