TM 9-4910-387-14-2
REASSEMBLY OF RH CONTROL PANEL ASSEMBLY
NOTE
1 24-VDC SWITCH (1), 500-1000-OFF
Wires were tagged with1
SWITCH (2), AND START COUNT
termination
points
at
SWITCH (3). Position on RH control
disassembly.
Ensure that
panel (4).
wires are connected to
correct locations.
3 WIRE TAGGED C13. Position one end
on START COUNT switch contact (9),
install screw (10) and tighten.
4 WIRE TAGGED C12. Position one end
on START COUNT switch contact (11),
install screw (12) and tighten.
5 WIRE TAGGED C14. Position one end
on 24-VDC switch contact (13), install
screw (14) and tighten.
6 WIRE TAGGED C6. Position one end
on 24-VDC switch contact (15), install 2
2 THREE LEGEND PLATES (5, 6, AND
THREE LEGEND PLATES (5, 6, AND
7) AND THREE LENS CAPS (8).
screw (16) and tighten.
INSTALL
6-211