OPERATING INSTRUCTIONS
Type AV 19-3
Vibrator Cleaning Tool Assembly:
Introduction
The primary use of this unit is intended for the salvaging of fine wire electrode type aircraft spark plugs, which have
previously been cleaned and found to be unsatisfactory for further use because of heavy lead compound deposits
remaining in the firing end cavity.
Unit Installation:
1. Securely mount unit onto a conveniently located work bench, with available 110-120 volt, 60 cycle, AC power
supply outlet.
2. Provide an exhaust duct or dust collector means under vibrator tool adapter head, in such a manner, so as when
salvaging operations are being performed, all lead compound deposit particles and dusting are positively carried
away from operation. (Continued exposure to lead compound dust should be avoided because of toxic effects).
3. Install two-pronged bayonet type cleaning tool into vibrator tool adapter head and secure with retaining flat head
screw.
A. Type CL-248 tool for AC-185, 285, SR-83P, HSR-83P and SR-47P type aircraft spark plugs.
B. Type CL-251 tool for AC-181 and 281 aircraft spark plugs.
C. For AC 3 electrode type plugs, install type CL-272 Dual Vibrator Cleaning Tool Holder onto unit tool holder
shaft. Install one type CL-273 and one type CL-274 3 blade tools, (one is left hand and other is right hand)
into dual tool holder with retaining flathead screws.
4. Insert extension cord 3 pronged plug into properly grounded 110-120 volt, 60 cycle, AC power supply outlet.
(Round pin of plug, or green colored wire attached to conversion plug provides positive grounding of unit).
16