OPERATING THE CLEANER
(l0mm;
14mm;
18mm
or
7/8")
and
1.
Select the proper rubber cleaner adapter
secure in place with steel holddown ring.
2.
Insert electrode end of spark plug into rubber cleaning adapter. Pull cleaner valve
lever -- (left rear of unit) forward to position marked Abrasive Blast Wobble
the top of the plug in a complete circle for 3 or 4 seconds (See Fig. #1.).
Continue
wobbling
action
and
push
the cleaner valve toward the rear of the
3.
B l a s t . This air blast Will remove abrasive particles
Air
unit -- position marked
from
the
spark
plug.
unsatisfactory, repeat the
Remove and inspect the spark plug. If the cleaning
4.
IS
cleaning cycle.
electrode sparking surfaces
Open
the
electrode
gap
slightly
and
vigorously
file
5.
with a point file.
Set the gap in the cleaned plug to the recommended setting for the
engine.
6.
CAUTION: Carefully inspect cleaned and gapped plug to ensure no particles of
abrasive material remain trapped in the plug that can loosen during
use and cause damage to the cylinder walls.