Every part of your jack
Keep your jack clean and well lubricated.
has been accurately machined and assembled, but frequent lubrication
is necessary if you are to obtain the benefit of this quality
Raise the saddle to full height and oil the surface
of the ram often, as well as all moving parts in the handle, the
pump piston and the-lifting mechanism.
Grease lift arm (4 fittings), handle pivot (1 fitting), wheels
and casters (1 fitting each), monthly or more frequently under
adverse working conditions.
U SE ONLY HYDRAULIC FLUID
( T R E S T L E S,
2. USE AS A LIFTING UNIT ONLY.,
VEHICLE) UNDER VEHICLE BEFORE STARTING WORK,
NOT LOAD JACK BEYOND ITS RATED CAPACITY,
ON HARD LEVEL SURFACES ONLY,
A L W A Y S CENTER LOAD ON LIFT SADDLE,
F AILURE TO HEED THESE WARNINGS AND CAUTIONS MAY
RESULT IN LOSS OF LOAD, DAMAGE TO EQUIPMENT AND/
OR FAILURE RESULTING IN PERSONAL INJURY OR
TO RAISE LOAD
Turn knob at end of handle clockwise to close release valve.
Center lift saddle under load and pump handle.
TO RELEASE LOAD
When not in use,
Slowly turn release knob counterclockwise.
always store jack with ram fully retracted and release valve