TM 9-4910-707-14&P
SET-UP
INSTRUCTIONS
1. Remove all packing material and replace
solid
2. Insert control handle assembly through support
plug in top of reservoir with vented plug.
t u b e and slide friction washer and nut through control
w i r e s . Guide control wi r e s into hole s i n spool piv o t s .
3 . Assemble friction washer and nut on control tube
4. Position control levers as shown on insert above.
a s s e m b l y . Tighten nut until it applies enough friction
Tighten set screws on front and rear of spool pivots
to control tube assembly to hold control tube assembly
when control handles are at position shown.
whenever it is swung from side to side. Tighten set
screw in nut at this position.
5. Slip the chuck rod retaining spring over the chuck
c a s t i n g and unwrap the tape and wire from the large
Acme thread.
5