TM 9-2330-211-14&P
4-21.
BRAKESHOES REPLACEMENT (Con't)
ACTION
LOCATION
ITEM
REMARKS
CLEANING AND INSPECTION
WARNING
DO NOT handle brakeshoes, brakedrums, or other
brake components unless area has been properly
cleaned.
There may be asbestos dust on these
components which can be dangerous if you touch it or
breathe it. Wear an approved filter mask and gloves.
Never use compressed air or a dry brush to clean brake
components.
Dust may be removed using an
industrial-type vacuum cleaner. Clean dust or mud
away from brake components with water and a wet, soft
brush or cloth. Failure to follow this warning may
result in serious illness or death to personnel.
Dry cleaning solvent P-D-680 is toxic and flammable.
Always wear protective goggles and gloves, and use
only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes, and DO NOT breathe vapors. DO
NOT use near open flame or excessive heat. The
solvent's flash point is 100F-138F (38C-59C). If you
become dizzy while using cleaning solvent, immediately
get fresh air and medical help. If solvent contacts eyes,
immediately wash your eyes and get medical aid.
13.
All metal parts
a.
Clean using dry cleaning solvent.
b.
Inspect for cracks or damage.
c.
If cracked or damaged, replace.
INSTALLATION
14.
Spider (10)
Shield (16)
Place in position and aline screw holes.
15.
Rear of spider (10)
Six screws (17)
Using flat-tip screwdriver, screw in and tighten.
16.
Axle (18)
Spider (10)
Slide onto axle (18) and aline screw holes.
17.
Spider (10)
Eight screws (11),
Using 3/4 in. socket, handle, and 3/4 in. wrench,
screw in and tighten.
and nuts (8)
18.
Two anchor pins (7)
Push into two anchor pin holes (13).
19.
Two anchor pins (7)
Two anchor pin
a.
Screw on until fingertight.
b.
Hold flattened ends (12) of anchor pins (7)
and nuts (15)
with 5/8 in. wrench.
c.
Using 1 1/8 in. wrench, screw in and tighten.
Change 2 4-55