TM 9-2590-506-13&P
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
TITLE
SECTION
PAGE
TROUBLESHOOTING PROCEDURES ................................................................................
MAINTENANCE PROCEDURES .........................................................................................
3-1.
GENERAL. This chapter describes the required
procedures for the converter assembly.
troubleshooting procedures and operator maintenance
Section I. TROUBLESHOOTING PROCEDURES
TITLE
PARA
PAGE
TROUBLESHOOTING ........................................................................................................
TROUBLESHOOTING TABLE .............................................................................................
3-2.
TROUBLESHOOTING. This section contains
3-3.
TROUBLESHOOTING TABLE.
locating and correcting some of deficiencies that may
develop with the converter assembly. Troubleshooting is
a.
the systematic isolation of defective components by
common malfunctions which you may find during
analysis of trouble symptoms (malfunctions), testing or
the operation or maintenance of the converter
inspecting to determine the defective component or
assembly.
You should perform the tests/
cause of malfunction, and then taking the appropriate
inspections and corrective actions in the order
corrective action. In most cases the operator can only
listed.
note the malfunctions by detecting irregularities and
reporting them to direct support maintenance.
b.
The manual cannot list all malfunctions that may
occur, nor all tests or inspections and corrective
actions. If a malfunction is not listed or is not
corrected by the listed corrective actions, notify
your supervisor.
3-1