TM 5-1940-322-10
0002 00
EQUIPMENT DESCRIPTION AND DATA (Contd)
LOCATION AND DESCRIPTION OF MAJOR COMPONENTS (Contd)
I
BOLLARD (MOORING BIT)--Consist of four bollards used to support and
secure lines to boat.
J
LADDER--Located in the rear of the boat; used to assist crew in and out of
boat while boat is in the water.
K
DIVING PLATFORM--Located at rear of boat transom, this platform is used
to assist crew during diving operations and contains an inspection flap for each
hydrojet.
L
DIVING PLATFORM FLAPS--Allows access to the hydrojet reverse
deflectors, hoses, and aft hull to inspect for damage.
M
HYDROJET HATCHES--The hatches open and close to gain access to the
hydrojet raw water strainers, hydraulic steering controls, scoop control cables,
drive belts, pump, reservoir, hoses, cylinders, control valves, tierod, and aft
bilge pump.
N
LIFTING EYES--Consist of four lifting eyes used to lift only the boat during
lifting operations. Do not use lifting eyes to lift boat and IBC together.
O
CLEATS--Two cleats used for securing rope lines.
P
LOWER DRAFT MARK--Marks are applied to both port and starboard side
Q
of BEB. Top of horizontal bar indicates normal load condition with fuel, BII,
boat operator, and two crewmembers.
R
UPPER DRAFT MARK--Marks are applied to both port and starboard side
of BEB. Top of horizontal bar indicates normal load condition with fuel, BII,
boat operator, two crewmembers, and 4,000 lbs of equipment.
S
PUSHKNEES--Provides front of boat with a flat vertical surface for pushing
bridge bays, anchoring bridge assemblies, and maneuvering raft assemblies.
0002 00-4
