TM 9-2320-211-10
(6) Place transmission gearshift lever (3) in FIRST gear (1) and move transfer selector
lever (2) down into LOW position (l). Make certain your engine is running normally.
(7) Upon entering water, pull out fording control handle (4). Follow instructions on data
plate (5), above the fording control handle.
WARNING
Do not attemt to ford your vehicle at depth greater than 78 inches.Limits speed to
3 or 4 miles per hour while fording.
(8) Upon leaving water, immediately push in fording control handle (4).
CAUTION
After fording, remove pipe plugs from breather caps on oil reservoir, swing motor
and bottom of base plate pivot and ring gear (see preceding page) and stow near
crane oil reservoir. Housing must be drained thoroughly before replacing plug in
base plate pivot.
TA 096217
2-144
