TM 9-2320-269-10
MOUNTING THE BASKET SUPPORT BRACKETS
NOTE
To mount the basket support brackets and the fiberglass baskets, the derrick leg, fully
extended, must be rotated and positioned out over the right side of the vehicle. The
basket support brackets, mounted to the head sheave assembly, must be positioned at
about the same height off the ground as the mating brackets on the baskets.
1.
With help from assistant, insert basket support shaft (1) into basket shaft support hole (2), on head sheave
assembly (3).
2.
Secure support bracket shaft (1) to basket support hole (2) with locking pin (4), releasing locking pin (4) by
pushing button (5) in handle.
3.
The basket support bracket for the opposite side Is mounted in the same manner, using the above
procedures.
MOUNTING THE BASKETS TO THE BASKET SUPPORTING BRACKETS
NOTE
One or both baskets must be installed before operating under these conditions. To install
or remove the basket(s), follow the steps below:
1.
Remove baskets and liners (1) from the back of M876 truck.
2.
Extend, rotate and lower derrick leg (2) until the basket support bracket (3) Is positioned at about the same
height off the ground as bracket (4) on basket (1).
TA 222612
2-124