TM 9-2320-269-10
OPERATION-AUXILIARY EQUIPMENT
NOTE
The below listed, hydraulically-operated, special equipment can be
connected at the back of the M876 truck or at the derrick leg. The chain
saw and impact wrench can be operated from the baskets. The only thing
that differs between the two connection locations is the position of the
basket/console control selector lever.
Remember, all four outriggers must be emplaced on the ground.
POLE PULLER
1.
Remove the pole puller (1) and base plate (2) from its stowed position on the truck.
2.
Position pole puller (1) on base plate (2) next to the pole to be pulled. Secure a chain (3) around
the pole, and place chain ends into the slotted bracket (4) on the top of pole puller (1).
3.
Connect hydraulic lines (5) and (6) into connections on pole puller (1) and into hydraulic power
source connections (7) on the truck.
TA 222623
2-137