TM 9-2320-279-10-2
M984E1 General Operating Procedures (Cont)
NOTE
Determine if winch will be operated with manual or
remote control. For manual control operation go to
step (17). For remote control operation continue with
step (12).
(12) Remove HEAVY DUTY WINCH REMOTE CONTROL (7) and remote
control cable (8) from stowage.
(13) Clean any dirt and water from cable ends (9) and receptacle (10).
(14) Connect remote control cable (8) to HEAVY DUTY WINCH REMOTE
CONTROL (7). Check that HEAVY DUTY WINCH switch (11) is set to
OFF.
(15) Remove cover (12) from receptacle (13). Clean any dirt or water from
receptacle.
(16) Connect remote control cable (8) to receptacle (13).
(17) Set POWER switch (14) to ON (LOW IDLE ONLY).
(18) Push and release LATCH switch (3) to ON.
(19) When using remote control, set H.D. WINCH CONTROL switch (2) to
REMOTE. When using manual control, set H.D. WINCH CONTROL
switch to MANUAL.
2-109
