TM
9-2320-279-10-2
M984E1 General Operating Procedures (Cont)
(37) Route other end of tow light cable (37) along disabled vehicle and
connect to rear electrical connector (38) on wrecker.
NOTE
If disabled vehicle will be lifted and towed, continue
with step (38).
If disabled vehicle will be towed with all tires on
paved roads only, raise crosstube enough to partially
unload disabled vehicle's front suspension. Keep
front tires in firm contact with ground and proceed
to step (43).
Lock disabled vehicle's steering (refer to M123 operator's manual).
(38)
Set POWER switch (39) to ON position.
(39)
Set HIGH IDLE switch (40) to CONTINUOUS.
(40)
Push and release LATCH switch (41). Engine speed will increase to
(41)
approximately 1500 rpm.
2-248