TM 9-2320-279-10-2
M984E1 General Operating Procedures (Cont)
2-77. TOW M151 (CONT).
(13) Install two 5-in. (127 mm) spacers (16) on crosstube (7).
NOTE
Make sure metal connector is located on either side of
belt brace and does not touch metal parts of adapters.
(14) Install two M151 adapters (15) on crosstube (7) with brace (17) facing
inside.
(15) Install two 4-in. (102 mm) spacers (18) on crosstube (7).
NOTE
End caps will hang over end of crosstube for M151 adapters.
(16)
Install two end caps (10) on crosstube (7).
(17)
Install two pins (9) and quick pins (8).
(18)
Attach two springs (1) on tow cylinders (2).
(19)
Extend both tow cylinders (2) 2 in. (50 mm) and lower lift cylinder (19)
until M151 adapters (15) are approximately 6 in. (152 mm) from
ground.
2-302
