TM 9-2320-285-10
3-7.
SERVICING (Continued)
b. Fuel Tank (Continued).
(1)
Remove filler cap from fuel tank.
(2)
Fill tank with diesel fuel (item 9, Appendix D).
(3)
Install filler cap.
c.
Radiator.
Checking and Filling:
(1)
Unlatch and raise radiator
access panel.
(2)
Check that coolant level
reaches the full mark, or 2 to
4 inches below the top of filler
neck on coolant reservoir.
NOTE
If coolant reservoir is empty, perform step (3) below. Otherwise go to step (4).
WARNING
Do not remove radiator cap from a hot radiator; stop the engine and allow it to cool before removing the
cap. This will avoid injury by scalding.
CAUTION
If coolant is hot do not add coolant to radiator unless engine is running. Allow engine to run for several
minutes to enable coolant being added to mix and circulate. Failure to observe this precaution may cause
engine damage.
(3)
Tilt cab 45 degrees, carefully remove radiator cap, and check coolant level in radiator. Fill to within two
inches of top of radiator if level is low. Reinstall radiator cap and lower cab to normal operating position.
3-27
