TM 9-2320-360-10
3-6. CHANGING TIRE ASSEMBLY
This task covers:
Removal
Installation
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Vehicle shut down (para 2-12).
Socket, Impact (Item 37,
Parking brake on (para 2-9).
Emergency marker kit set out
Warning Device Kit (Item 39,
Emergency flashers on
Wrench, Adjustable (Item 41,
CTIS shut off (para 2-13).
Wrench, Air Powered (Item 43,
Wrench, Open-End (Item 44,
Tools and Special Tools
Adapter (Item 1, Appendix B)
Chocks, Wheel (2)(Item 11,
Wrench, Tube, 3/4 in. (Item 45,
Extension, Wrench ( Item 13,
Materials/Parts
Handle, Extension (Item 17,
Rags (Item 14, Appendix D)
Gloves, Leather (Appendix C)
Handle, Extension, 40 In. (Item 17.1,
General Safety Instructions
Handle, Sliding (Item 19,
The two piece handle supplied
with the hydraulic jack must
Hose Assembly Air (Item 21,
not be used. Only use the
40 in. (102 cm) extension
Jack, Hydraulic (2)(Item 22,
handle to operate the jack.
Failure to comply may result in
Pins, Adapter (2)(tem 30.1,
injury or death to personnel.
Plate, Jack (Item 28, Appendix B)
Personnel Required
Socket, Impact (Item 36,
Two
WARNING
HET M1070 Tractor must be parked in a safe area, out of traffic,
where there is no danger to personnel changing the tire
assembly.
HET M1070 Tractor must be parked on hard, level surface where
jacks will have a stable surface. Attempting to change the tire
assembly on unlevel or soft surface may result in truck falling
and injury or death to personnel.
Change 1 3-45
