Items that are included in kits and sets are listed
below the name of the kit or set.
(4) Spare/repair parts that make up an assembled item are
listed immediately following the assembled line item entry.
Part numbers for bulk materials are referenced in
this column in the line item e n t r y for the item to be
(6) When the item is not used with all serial numbers of
the same model, the effective serial numbers are shown on the
last line(s) of the description (before the UOC).
(7) The usable on code, when applicable (see paragraph 5,
(8) In the Special Tools List section, the basis of issue
(BOI) appears as the last line(s) in the entry for each special
tool , special TMDE, and other special support equipment.
density of equipments supported exceeds density spread indicated
on the BOI, the total authorization is increased proportionately.
The statement "END OF FIGURE" appears just below the
last item description in Column 5 for a given figure in both
Section 11 and Section III.
QTY [Column (6)].
The QTY (quantity per figure column)
indicates the quantity of the item used in the breakout shown on
the illustration figure, which is prepared for a functional
group, subfunctional group, or an assembly. A "V" appearing in
this column in lieu of a quantity indicates that the quantity is
v a r i a b l e and the quantity may vary from application to
Explanation of Columns (Section IV).
NATIONAL STOCK NUMBER (NSN) INDEX.
This column lists the NSN by
STOCK NUMBER column.
National Item Identification Number (NIIN) sequence.
consists of the last nine digits of the NSN (i.e., 01-674-1467).
When using this column to locate an item, ignore the first 4
digits of the NSN (i.e., 5305- ) .
However, the complete NSN
should be used when ordering items by stock number.
This column lists the number of the
The figures are in
figure where the item is identified/located.
numerical order in Section II and Section III.
The item number identifies the item
associated with the figure listed in the adjacent FIG. column.