TM 9-2330-246-14
4-76. LEVELING JACK REPLACEMENT (XM1005 AND XM1007).
This Task Covers:
Installation
c.
Removal
a.
b.
Cleaning and Inspection
initia/ Setup:
Tools/Test Equipment:
Materials/Parts:
Brush (Item 7, Appendix E)
General mechanic's tool kit
Two cotter pins
REMOVAL
a.
Remove cotter pin (10), washer (9), and headed pin (8). Discard cotter pin.
1.
Release three pin and chain assemblies (2) and remove two braces (l).
2.
Remove cotter pin (6), washer (5), and headed pin (3). Discard cotter pin.
3.
4.
Release pin and chain assembly (7) and remove housing (4) from dolly rear crossmember,
CLEANING AND INSPECTION
b.
Clean mud and dirt from all exposed surfaces using water and a stiff brush.
1.
Inspect housing for damage. Replace leveling jack if housing is damaged.
2.
Check operation of jackscrew. Lubricate as required (Chapter 3, Section l). Replace leveling jack if jackscrew is
3.
defective.
Inspect pin and chain assemblies for wear and damage. Replace defective parts.
4.
TA700280
4-182
