TM 9-2330-246-14
4-131. HEATER FUEL LINES AND FITTINGS REPLACEMENT (M373A2D AND M373A5)
(Con't).
BULKHEAD CONNECTOR INSTALLATION
d.
1.
Underneath semitrailer, install bulkhead connector (19), flatwasher (20), and new gasket (21).
2.
Connect fitting (18) to bulkhead connector (19).
Inside semitrailer install new gasket (11), flatwasher (10), and nut (9) on bulkhead connector (19).
3.
4.
Connect fitting (8) to bulkhead connector (19).
Install each plate (23) using five screws (24). Ensure that grommet (7) is properly seated between plates,
5.
FUEL PUMP LINE REMOVAL
e.
1.
Disconnect fitting (18) from bulkhead connector (19) and allow fuel to drain.
Disconnect fitting/(l 2) from elbow (15) installed on fuel pump (13).
2.
TA700377
4-316