TM
9-2330-251-14&P
LUBRICATION CHART
TRAILER, CARGO: 1/4-TON, 2-WHEEL
M416 (NSN 2330-00-706-5495)
M416A1 (NSN 2330-01-046-2855)
area. Avoid contact with skin, eyes, and
Intervals (on-condition or hard time) and related
clothes, and DO NOT breathe vapors. DO
man-hour times are based on normal operation.
NOT use near open flame or excessive heat.
The man-hour time specified is the time you need
The solvent's flash point is 100F-13OF
to do all services prescribed for a particular inter-
val. Decrease the intervals if your lubricants are
(38C-59C). If you become dizzy while us-
ing cleaning solvent, immediately get fresh
contaminated, or if you are operating equipment
under adverse conditions, including long-
air and medical help. If solvent contacts
eyes, immediately wash your eyes and get
er-than-usual operating hours. The intervals may
medical aid.
be extended during periods of low activity. If ex-
tended, adequate preservation precautions must
be taken.
Clean all fittings and area around lubrication points
with dry cleaning solvent (Item 10, Appendix E) or
Dotted leader lines indicate lubrication is required
equivalent before lubricating equipment. After lu-
on both sides of the equipment.
brication, wipe off excess oil or grease to prevent
accumulation of foreign matter.
WARNING
The lowest level of maintenance authorized to lu-
Dry cleaning solvent P-D-680 is toxic and
bricate a point is indicated in parentheses by use
of the following: (C) Operator/Crew; or (0) Orga-
flammable. Always wear protective goggles
nizational Maintenance.
and gloves, and use only in a well-ventilated
3-3
