TM 9-2330-357-14&P
5-1. OUTRIGGER RELAY BOX REPAIR (Con't).
3. Tag and disconnect wires from rear of two large relays (14).
4. Remove screw (18), two bolts (17), three washers (16), bracket (23), and three spacers (15).
5. Partially remove two large relays (14) to gain access to wiring in rear of box (4).
6. Tag and remove wiring in rear of box (4).
7. Remove two large relays (14) and bracket (13).
8. Tag wiring on two small relays (9). Unsolder connections and disconnect wiring (TB SIG 222).
9. Remove four screws (11), bracket (10), eight nuts (12), and two small relays (9).
10. Tag and disconnect ground lead connection (8).
11. Remove four screws (1), power lead receptacle (2) with wiring and gasket (3). Discard gasket.
12. Remove four screws (27), actuator lead receptacle (26), and gasket (25). Discard gasket.
13. Remove four screws (6), control lead receptacle (7), and gasket (5). Discard gasket.
14. If damaged, remove insulator plate (24) from bottom of box (4).
b. CLEANING AND INSPECTION I
WARNING
Dry cleaning solvent, P-D-680, Is toxic and flammable. Always wear protective
goggles and gloves, and use only In a well-ventilated area. Avoid contact with skin,
eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame or
excessive heat. The solvent's flash point is 100 -138 (38 -59 ). If you become
F
F
C
C
dizzy while using cleaning solvent, Immediately get fresh air and medical help. If
solvent contacts eyes, immediately wash your eyes and get medical aid.
1. Remove all buildup of grease or dirt by using a clean rag or medium bristle brush and dry cleaning solvent,
and allow to dry.
2. Inspect wiring for damage, deteriorated insulation, and broken or frayed conductors.
3. Inspect each relay for cracks or signs of burning.
4. Inspect connectors for broken, loose, bent, or missing pins or cracked connector bodies.
5-3
