TM9-2330-372-14&P
The work time figure represents the average time required to restore an item (assembly, subassembly, component,
module end item, or system) to a serviceable condition under typical field operating conditions. This time includes
preparation time, troubleshooting time, and quality assurance/quality control time in addition to the time required to
perform the specific tasks identified for the maintenance functions authorized in the maintenance allocation chart. The
symbol designations for the various maintenance categories are as follows:
C ..................... Operator or Crew
O ..................... Organizational Maintenance
F ..................... Direct Support Maintenance
H ..................... General Support Maintenance
D ..................... Depot Maintenance
e. Column (5) Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual tools)
and special tools, TMDE, and support equipment required to perform the designated function.
f. Column (6) Remarks. This column shall, when applicable, contain a letter code in alphabetic order, which shall
be keyed to the remarks contained in Section IV.
B-4. EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS, SECTION III.
a. Column (1) - Reference Code.- The tool and test equipment reference code correlates with a code used in the
MAC, Section II column 5.
b. Column (2) - Maintenance Category. The lowest category of maintenance authorized to use the tool or test
equipment.
c. Column (3) - Nomenclature. Name or identification of the tool or equipment.
d. Column (4) - National Stock Number. The National stock number of the tool or test equipment.
e. Column (5) - Tool Number. The manufacturer's part number.
B-5. EXPLANATION OF COLUMNS IN REMARKS, SECTION IV.
a. Column (1) - Reference Code. = The code recorded in column 6, section II.
b. Column (2) - Remarks. = This column lists information pertinent to the maintenance function being performed as
indicated in the MAC, section II.
B-3
