TM 9-2330-372-14&P
APPENDIX H
TORQUE TABLE
STANDARD CAPSCREW MARKINGS AND TORQUE
Current Usage
Much Used
Much Used
Used at Times
Used at Times
Minimum Tensile
To Vh-9, 000 (478)
To 3V.120, 000 (827)
To 518-140, 000 (965)
150, 000 (1034)
Strength PSI
To-1Y4-4, 000 (421)
To 1-115, 000 (793)
To -3/4 133, 000 (917)
MPa
To 155, 000 (379)
Quality of Material
Indeterminate
Minimum Commercial
Medium Commercial
Best Commercial
SAE Grade Number
1 or2
5
6 or 7
8
Capscrew Head Markings
Manufacturer's marks
may vary
These are all SAE G- 3)
Grade 5 (3 line)
Capscrew Body Size
Torque
Torque
Torque
Torque
(Inches)--(Thread)
Ft-Lb (N-m)
Ft-Lb (N-m)
Ft-Lb (N-m)
Ft-Lb (N-m)
1/4 --205(7)
8(11)
10(14)
12(16)
-28
6(8)
10(14)
14(19)
5/16--1811(15)
17(23)
19(26)
24(33)
-24
13(18)
19(26)
27(37)
3/8-16
18(24)
31(42)
34(48)
44(60)
-24
20(27)
35(47)
49(66)
7/17-14
28(38)
49(6S)
55(75)
70(95)
-20
30(41)
55(75)
78(106)
-13
39(53)
75(102)
85(115)
105(142)
-20
41(568)
85(115)
120(1631
9/16-12
51(69)
110(149)
120(163)
155(210)
-18
55(75)
120(153)
170(231)
5/8-11
83(113)
150(203)
167(228)
210(285)
-18
95(129)
170(231)
240(3251
3/4-10
105(142)
270(366)
280(380)
375(508)
-16
115156)
295(400)
420(569)
7/8-9
1
60(217)
395(536)
440(597)
605(820)
-14
175(237)
435(590)
675(915)
1-8
235(319)
590(800)
680(895)
910(1234)
-14
250(339)
860(895)
990(1342)
1. Always use the torque values listed above when definite specifications are not available.
Note: Do not use standard values In place of those specified in other sections of this manual; special attention should be observed
when using SAE Grade 6. 7 and 8 capscrews.
2 The above is based on use of clean and dry threads.
3. Reduce torque by 10Svwhen engine oil Is used as a lubricant.
4. Reduce torque by 20% If new plated capscrews are used.
Caution: Capscrews threaded into aluminum may require reductions In torque of 303% or more, unless inserts are used.
H-1/(H-2 blank)