TM -9-2330-373-14 & P
3-5. PAINTING AND IDENTIFICATION MARKING (cont)
WARNING
To prevent injury to personnel, avoid excessive inhalation of vapors. All cleaning and stenciling
procedures must be performed in a well-ventilated room, or outdoors. A fire extinguisher must be
positioned adjacent to the work area.
(1) Remove oil and grease from equipment.
(2) Apply paint to stencil with dabbing motion.
(3) Remove stencil and fill in spaces to provide for continuous lines in the letters and numerals.
(4) Allow paint to dry for 24 hours.
Section II. TROUBLESHOOTING PROCEDURES
3-6. INTRODUCTION
Table 3-1 lists the common malfunctions which you find during the operation or
maintenance of
the semitrailer, van, or
its
components. You should perform the tests/inspections and corrective actions in the order listed.
This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions. If a malfunction
is not listed or is not corrected by listed corrective action, notify your supervisor.
TA 314744
3-7