TM 9-2330-376-14&P
LUBRICATION
CHART
CHASSIS,
TRAILER:
5-TON,
4-WHEEL,
GEMSS
XM979
(NSN
TRAILER,
FLATBED:
5-TON,
4-WHEEL
XM1061
(NSN
M1061A1
(NSN
TRAILER,
GENERAL
PURPOSE,
FLATBED:
7-1/2-TON
XM1073
(NSN
Intervals (on-condition or hard time) and related
area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT
man-hour times are based on normal operation. The
use near open flame or excessive heat. The
man-hour time specified is the time you need to do all
solvent's flash point is 100F-138F
services prescribed for a particular interval. De-
(38C-59C). If you become dizzy while using
crease the intervals if your lubricants are contami-
cleaning solvent, immediately get fresh air and
nated, or if you are operating equipment under
medical help. If solvent contacts eyes,
adverse conditions, including longer-than-usual op-
immediately wash your eyes and get medical
aid.
crating hours. The intervals may be extended during
periods of low activity. If extended, adequate preser-
Clean all fittings and area around lubrication points
vation precautions must be taken.
with dry cleaning solvent (Item 14, Appendix E) or
equivalent before lubricating equipment. After lubri-
Dotted leader lines indicate lubrication is required on
cation, wipe off excess oil or grease to prevent accu-
both sides of the equipment.
mulation of foreign matter.
WARNING
The lowest level of maintenance authorized to lubri-
cate a point is indicated in parentheses by use of the
Dry cleaning solvent, P-D-680, is toxic and
following: (C) Operator/Crew or (O) Organizational
flammable. Always wear protective goggles
Maintenance.
and gloves, and use only In a well-ventilated
3-3
