TM 9-2330-376-14&P
4-58. ODOMETER DRIVE SHAFT AND MOUNTING PLATE REPLACEMENT (XM979)
(Con't).
Remove two screws (16), Iockwashers (15), and spacer plate (14) from rear axle (17). Discard Iockwashers.
3.
4.
Remove two screws (22), Iockwashers (23), and
spacer plate (21) from chassis. Discard lock-
washers.
Loosen swivel nut (18) at connector (19) and slide
5.
drive shaft (8) out of mounting plate (20). Remove
drive shaft.
6.
Remove connector (19) from mounting plate (20).
7.
Remove eight screws (13), Iockwashers (12),
mounting plate (20), and gasket (11) from rear axle
(17). Discard gasket and Iockwashers.
Remove three screws (3), Iockwashers (2), and
8.
hub adapter plate (1). Discard Iockwashers.
1.
Install connector (19) on mounting plate (20).
2.
Install drive shaft (8) through new gasket (11) and mounting plate (20).
NOTE
It may be necessary to use a piece of wire to help guide drive shaft through rear axle.
Feed drive shaft (8) through rear axle (17).
3.
TA701004
4-106
