TM 9-2330-381-14
27.
Using one person to lift both side plates (31), have second person aline and install lower tie bar (30) into place
between both side plates (31).
28.
While still holding both side plates (31) upward, aline and install upper tie bar (32) over two threaded rods (29)
and into slots in both side plates (31).
29.
Secure upper tie bar (32) in place by installing two wingnuts (28) onto threaded rods (29).
30.
Install detent pin (33) into adjustment rod (34). Thread adjustment rod (34), pin end of rod on same side as
slotted end of thrust bar (35), so that approximately 12 inches (30 cm) of adjustment rod (34) stick out of flat side
of thrust bar (35).
5-21