TM 9-2330-381-14
5-12.
AXLE ASSEMBLY (CONT)
CAUTION
Be sure ultra bushing and spindle are properly alined or damage to equipment may
result.
9.
Operate hydraulic hand pump until hydraulic ram (23) extends to its full travel of 3 inches (7.62 cm).
10.
Release pressure on hydraulic hand pump and allow hydraulic ram (23) to relax to retracted position. Hand
tighten hex nut (36) to remove slack.
11.
Repeat steps 9 and 10 until ultra bushing (43) is fully onto spindle.
12.
Release pressure on hydraulic hand pump and allow hydraulic ram (23) to relax to retracted position. Remove
hex nut (36) and hydraulic ram (23) from adjustment rod (34).
13.
Remove two capscrews (26), lockwashers (27), and spacer (44) from hydraulic ram (23).
5-28
