TM 9-2330-381-14
NOTE
Rod seal is in four parts, one clear and three black. It may be necessary to remove
tape each time a part is removed. If so, reapply tape and continue removing parts
until entire rod seal is removed.
7.
Using moderate force, push plunger rod (11) into cylinder assembly (9). Extend plunger rod (11) and remove
tape and all four parts of rod seal (12). Discard rod seal and tape.
8.
Compress cylinder and insert stop ring tool and suitable prybar onto cylinder assembly (9). Unscrew piston ring
(13) and remove plunger rod (11) from cylinder assembly (9); Remove stop ring tool.
5-129