TM 9-2330-383-14&P
The work time figure represents the average time required to restore an item
(assembly, subassembly, component, module, end item or system) to a serviceable
condition under typical field operating conditions. This time includes preparation
time, troubleshooting time and quality assurance/quality control time in addition
to the time required to perform the specific tasks identified for the maintenance
functions authorized in the maintenance allocation chart. The symbol designations
for the various maintenance categories are as follows:
C ......................
Operator or crew
O ......................
Unit maintenance
F ......................
Direct support maintenance
H ......................
General support maintenance
D ......................
Depot maintenance
e. Column 5, Tools and Equipment. Column 5 specifies, by code, those common tool
sets (not individual tools) and special tools, TMDE and support equipment required
to perform the designated function.
f. Column 6, Remarks. This column shall, when applicable, contain a letter code,
in alphabetic order, which shall be keyed to the remarks contained in section IV.
B-4. EXPLANATION OF COLUMNS IN THE TOOL AND TEST EQUIPMENT REQUIREMENTS,
SECTION III
a. Column 1, Reference Code. The tool and test equipment reference code
correlates with a code used in the MAC, Section II, Column 5.
b. Column 2, Maintenance Category. The lowest category of maintenance authorized
to use the tool or test equipment.
c. Column 3, Nomenclature. Name or identification of the tool or test equipment.
d. Column 4, National Stock Number. The National Stock Number of the tool or
test equipment.
e. Column 5, Tool Number. The manufacturer's part number.
B-5. EXPLANATION OF COLUMNS IN REMARKS
a. Column 1, Reference Code. The code recorded in column 6, Section II.
b. Column 2, Remarks. This column lists information pertinent to the maintenance
function being performed as indicated in the MAC, Section II.
B-3
