TM 9-2330-383-14&P
(3)
ITEM Column. The item number identifies the item associated with the
figure listed in the adjacent FIG. column. This item is also identified by the NSN
listed on the same line.
b. PART NUMBER INDEX. Part numbers in this index are listed by part number in
ascending alphanumeric sequence (i.e., vertical arrangement of letter and number
combination which places the first letter or digit of each group in order A through
Z, followed by the numbers 0 through 9 and each following letter or digit in like
order).
(1)
CAGEC Column. The CAGEC is a 5-digit numeric code used to identify the
manufacturer, distributor, or Government agency/activity that supplies the item.
(2)
PART NUMBER Column. Indicates the primary number used by the
manufacturer (individual, firm, corporation, or Government activity), which
controls the design and characteristics of the item by means of its engineering
drawings, specifications, standards, and inspection requirements to identify an
item or range of items.
(3)
STOCK NUMBER Column. This column lists the NSN for the associated part
number and manufacturer identified in the PART NUMBER and CAGEC columns to the
left.
(4)
FIG. Column. This column lists the number of the figure where the item
is identified/located in Section II and Section III.
(5)
ITEM Column. The item number is that number assigned to the item as it
appears in the figure referenced in the adjacent FIG. column.
c. FIGURE AND ITEM NUMBER INDEX.
(1)
FIG. Column. This column lists the number of the figure where the item
is identified/located in Section II and Section III.
(2)
ITEM Column. The item number is that number assigned to the item as it
appears in the figure referenced in the adjacent FIG. column.
(3)
STOCK NUMBER Column. This column lists the NSN for the item.
(4)
CAGEC Column. The CAGEC is a 5-digit numeric code used to identify the
manufacturer, distributor, or Government agency/activity that supplies the item.
(5)
PART NUMBER Column. Indicates the primary number used by the
manufacturer (individual, firm, corporation, or Government activity), which
controls the design and characteristics of the item by means of its engineering
drawings, specifications, standards, and inspection requirements to identify an
item or range of items.
Change 1
F-7
