TM 9-2330-384-14&P
Table 4-2. Unit Troubleshooting Procedures (Con't).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 7.
Check continuity in brown wire assembly between ground terminal at blackout light
and connector inside condulet at rear dam.
If there is continuity, brown wire assembly is O.K. Go to step 8.
If there is no continuity, check for loose or corroded mounting hardware where
Check for a loose or damaged ground terminal at blackout light end of brown
wire. If mounting hardware at blackout light is loose, tighten. If mounting
malfunction still exists, go to step 8.
NOTE
White receptacle wire connects pin #1 of receptacle to brown wire assembly
inside condulet. Black receptacle wire connects pin #2 of receptacle to blue
wire assembly inside condulet.
Step 8.
Check for continuity and a short in white and black receptacle wires inside condulet
at rear dam.
If both white and black receptacle wires have continuity, receptacle with wires
is O.K. Go to step 9.
If there is no continuity in either or both wires, or if a wire is shorted, replace
step 9.
NOTE
Pin #1 of cable's male plug corresponds to white cable wire. Pin #2
corresponds to black cable wire.
Step 9.
Remove dome from convoy warning light. Unplug terminals of white and black cable
wires from convoy warning light (see paragraph 4-23). Check for continuity and a
short in cable.
If there is continuity, cable is O.K. Replace convoy warning light (see
If there is no continuity, or if cable is shorted, replace cable (see paragraph
4-23). If
malfunction still exists, replace convoy warning light (see paragraph
Step 10. Troubleshoot tractor electrical system (see TM 9-2320-273-20 or TM 9-2320-
283-20).
4-22