TM 9-2330-384-14&P
4-63. HOSE AND GAGE STICK TUBE ASSEMBLY REPLACEMENT.
Installation
b.
a.
Removal
Materials/Parts:
Equipment Conditions:
Ref Conditions
Ten locknuts
--
Transfer hoses and gage stick
General Safety Instructions:
removed.
Hose and gage stick tube assembly is
Tools:
heavy and awkward to handle. Use caution
and assistance during removal and installa-
Tool kit, general mechanic's
tion.
Personnel Required: Three
a. REMOVAL
WARNING
Hose and gage stick tube assembly (10) is heavy and awkward to handle.
Use caution and assistance during removal. Failure to follow this warning
may result in injury to personnel.
NOTE
If removing lockspring (9) from door (11), perform step 4.
(1)
Remove four locknuts (4) and washers (5) at four top hook bolts (6). Discard locknuts.
(2)
Pull down on four retaining straps (7) and remove hose and gage stick assembly (10).
(3)
If a retaining strap (7) is damaged, remove locknut (14) and washer (13) from bottom hook
bolt (6). Remove retaining strap. Remove two hook bolts from retaining strap. Discard
locknut.
(4)
Remove two locknuts (12), screws (3) and washers (2). Remove lockspring (9) from mount-
ing channel (8). Remove lockspring from other end in same manner. Discard locknuts.
b. INSTALLATION
WARNING
Hose and gage stick tube assembly (10) is heavy and awkward to handle.
Use caution and assistance during installation. Failure to follow this warning
may result in injury to personnel.
NOTE
If installing lockspring (9), perform step 1.
Install lockspring (9) to mounting channel (8) with two washers (2), screws (3), and new
(1)
locknuts (12). Close door (11) and secure with lockspring. Repeat to install lockspring on
other end.
4-190