TM 9-2330-386-14&P
NOTES
1. FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD TEMPERATURES BELOW -lOF
(-23C) Remove lubricants prescribed in
the key for temperatures above -lOF (-23C). Clean parts
with dry cleaning solvent (SD-2). Relubricate with lubricants specified in the key for temperatures
OF to -65F (-18C to -54C).
2. KINGPIN AND PLATE Apply a thin coat of grease (GAA) to kingpin and kingpin plate. If
vehicle is in continuous use, apply grease weekly.
3. OIL CAN POINTS Lubricate slack adjuster clevis pins, storage box hinges and latches, cargo tie-
down rings, bulkhead extension hinges, and landing gear crank, lower legs and sand shoe pins with
lubricating oil (OE). OE/HDO- 15/40 is the preferred lubricant when temperatures are above +5 F
(-15C).
4. AXLE ENDS Check daily for lubricant at bottom OIL LEVEL mark in sight glass, Using clean
cloth moistened with dry cleaning solvent (SD-2), clean area around rubber plug before removing. Pull
rubber plug from hub cap, add lubricant (GO) to OIL LEVEL mark as necessary, and install rubber
plug.
5. DO NOT LUBRICATE SPRINGS, BRAKE ANCHOR PINS, OR BRAKE ROLLERS
Copy of this lubrication chart will remain with the equipment at all times;
instructions contained herein are mandatory.
Lubrication
Chart
(Sheet
3
of
3)
3-4