Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Custom Search
 
  
 
TM 9-2330-394-13&P
BRAKE SYSTEM TROUBLESHOOTING - Continued
0037 00
BRAKE SYSTEM - Continued
Table 1. Brake System Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
Loosen connector retaining
4.
Check to see if continuity is
11. ANTI-LOCK BRAKING
clip on connector BU2.
present across left rear ABS
SYSTEM (ABS) DIAGNOSTIC
control sensor harness
TOOL BLINKS FIVE TIMES IN
connector with jumper wire
SERIES: LEFT REAR ABS
across connector BU2.
WHEEL SPEED SENSOR
FAULT (MTVT) - CONTINUED
2.
Disconnect connector BU2
from ABS ECU.
3.
Install jumper wire across
connector BU2.
4.
Connect positive (+) probe
of digital multimeter to one
pin of ABS control sensor
harness connector.
5.
Connect negative (-) probe
of digital multimeter to other
pin of ABS control sensor
harness connector and note
reading on digital
multimeter.
6.
If continuity is not present,
replace ABS control sensor
7.
If continuity is present,
replace ABS ECU (WP 0065
0037 00-51


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business